HomespaceProductsspaceCustom MadespaceDownloadspaceSupportspaceAbout Us

Upgrade information on PM16C-04XD (L)


Version Details
Version UP File
1.51 14-02-28

PM16C-04X

Firmware update for hardware update to remove unexpected hold off signal output when you turns on the power. This update is only for XDL. PM16C_V1.51.S
1.50 14-02-18

PM16C-04X

The problem that drives only backlash value when you use the old command which drives with backlash move is fixed. It occurs firmware version V1.48 and V1.49. PM16C_V1.50.S
1.49 13-12-27

PM16C-04X

The problem that timing out signal output start point and end point of CH1 are initialized to zero when you turns on the power is fixed. PM16C_V1.49.S
1.48 13-06-18

PM16C-04X

At the time of a hold-off output,after canceling the hold-off signal,the time to motor drive could be changed. PM16C_V1.48.S
1.47 13-05-17

PM16C-04X

  • The command (STS command) which reads thedetailed state for every channel was added.
  • A flicker of a display for indication was reduced.
PM16_V1.47.EXE
1.46 13-02-06

PM16C-04X

The problem the channel set up at the time ofswing operation set as hold-off at the timeof power on was corrected. PM16_V1.46.EXE
1.45 12-09-19

PM16C-04X

The problem that the response of command is sometimes lost during oscillation drive mode was corrected. PM16_V1.46.EXE
1.44 12-04-01

PM16C-04X

Enabled to set up backlash correction value onthe SETUP screen in the local mode. PM16_V1.44.EXE
1.43 11-11-09

PM16C-04X

  • Oscillation drive mode was added.
  • When the speed of LSPD was changed at remotemode, the problem by which setting was notreflection immediately was corrected.
PM16_V1.43.EXE
Manual